New DSO Oscilloscopes from HAMEG

All types are MSO-ready – it suffices to connect a logic probe (option HO3508) in order to analyze 8 digital channels. With the known option HOO10 two freely selectable serial protocols of the types I2C, SPI and/or UART/RS-232 can be analyzed, hardware-supported and time-synchronous. This is possible both on the analog and the digital channels.

New is the option HOO11 which enable the analysis of these serial protocols on the analog channel. Even with the 2 channel instruments 3-wire buses such as SPI can be analyzed this way by making use of the external trigger input.(additional probe recommended)

The HOO11 will be delivered with each HMO7xx, 10xx, 15xx, 20xx at no cost in the year of introduction.

Technical parameters:

• 2 GSa/s Real Time,
• Low Noise Flash A/D Converter (Reference Class),
• 2 MPts Memory, Memory zoom up to 50,000:1,
• MSO (Mixed Signal Opt. HO3508) with 8 Logic Channels,
• Serial Bus Trigger and Hardware accelerated Decode, I2C, SPI, UART/RS-232 (Opt. HOO10, HOO11),
• 8 User definable Markers for easy Navigation,
• Pass/Fail Test based on Masks,
• Vertical Sensitivity 1 mV/div.,
• Offset Control ±0.2...±20 V (HMO20xx, HMO15xx),
• 12 div. x-Axis Display Range, 20 div. y-Axis Display Range (VirtualScreen),
• Trigger Modes: Slope, Video, Pulsewidth, Logic, Delayed, Event,
• Component Tester, 6 Digit Counter, Automeasurement, Formula Editor, Ratiocursor, FFT for Spectral Analysis,
• Crisp 16.5 cm (6.5”) TFT VGA Display, DVI Output,
• Lowest Noise Fan,
• 3 x USB for Mass Storage, Printer and Remote Control optional IEEE-488 (GPIB) or Ethernet/USB,
• Made in Germany.