Notice

You are currently browsing the website for customers from France. We recommend switching to the United States version of the site, optimized for your region.
France
€ EUR
Prices without VAT

How to Easily Monitor the Battery State of Charge

The LTC2944 is a battery monitor that measures charge, voltage, current and temperature to 1% accuracy, the essential parameters required to accurately assess battery state of charge (SoC).
This is an archive article published 08/10/2017. Some information may no longer be up to date and in line with the current state. Please contact us in case of interest.

In the present time, more and more devices are using rechargeable battery as a backup source during a power supply failure. These devices should monitor battery state of charge. For certain types of devices, such as remote alarm on passenger goods lifts, monitoring is mandatory (EN81-28, §4.1.3. Battery check).

Charge/discharge current creates voltage drop Vsense across the sense resistor. This voltage is applied to an auto-zeroed differential analogue integrator. Integration time depends on current, sensing resistor, programmable pre-scaler M and internal REHHI, REFLO thresholds. For M=1, AC register is incremented during charging or decremented during discharging after integrator voltage make one cycle REFLO-REFHI-REFLO. For M> 1, M cycles are required to increment/decrement register.

Analogue integrator uses a similar principle as dual slope integrating ADC, which allows great reduction of offset voltages influence. The relative integration error due to offset (CEov) can be expressed by: CEov = (Vos/Vsense)^2.

Many other devices convert Vsense to digit by ADC and calculate integral in digital domain. In such architecture, the offset Vos causes relative integration error of Vos/Vsense. For small Vsense values, Vos can be the main source of error. As an example, at 1mV input signal and voltage offset of Vos = 20µV, digital integration results in a 2% error, whereas the error is only 0.04% (a factor of50 times smaller!) using the analogue integration approach of LTC2944.

LTC2944 is suitable for all battery chemistry and voltages in range 3.6 to 60V. External current sense resistor and programmable pre-scaler allow using a wide range of battery capacities.

LTC2944 measures battery voltage, current flowing through sense resistor and chip temperature by 14-bit no latency delta-sigma ADC. Host reads measured values over an I²C/SMBus-compatible 2-wire interface that is also used to configure chip. The host can program high and low thresholds for all measured parameters, which if tripped, signal an alert using either the SMBus alert protocol or by setting a register flag.

LTC2944 is pin and function compatible with LTC2943 and LTC2943-1 with integrated sense resistor.

For further information about Linear Technology products, please look at our LT web pages or contact us at linear-technology@soselectronic.com.

Features:
  • 3.6V to 60V operating range without external level shifting circuitry.
  • Suitable for all battery chemistry and a wide range of capacity.
  • Measures battery charge, battery voltage, current through sense resistor and temperature.
  • High side sense, ±50mV sense voltage range.
  • 1% voltage, current and charge accuracy.
  • I2C/SMBus interface.
  • Configurable alert output/charge complete input.
  • Quiescent current less than 150μA.
  • 8-Lead 3mm × 3mm DFN package.
Do not miss these articles

Do you like our articles? Do not miss any of them! You do not have to worry about anything, we will arrange delivery to you.

Main products


LTC2944IDD#PBF ANALOG DEVICES  
LTC2944IDD#PBF

60V Battery Gas Gauge DFN-8

Circuit for Battery Chargers

Ord. No.: 259446
Manufacturer: ANALOG DEVICES
  • ADD TO CART
  • Get Quote
  • Add to favorites
  • Add to watchdog
  • Add item to compare
Get Quote

Additional products

LTC2943IDD#PBF ANALOG DEVICES
ANALOG DEVICES

Ord.number: 233983

On request

  • ADD TO CART
  • Get Quote
  • Add to favorites
  • Add to watchdog
  • Add item to compare
LTC2942IDCB#TRMPBF ANALOG DEVICES
ANALOG DEVICES

Ord.number: 98367

On request

LTC2942IDCB#TRMPBF

Circuit for Battery Chargers

Battery Gas Gauge w/Temperature & Voltage Measurement DFN6

  • ADD TO CART
  • Get Quote
  • Add to favorites
  • Add to watchdog
  • Add item to compare
LC-R127R2PG PANASONIC
PANASONIC

Ord.number: 2612

Alternative components:

NP7-12

LC-R127R2PG

Rechargeable Batteries

Lead Acid Battery 12V 7,2Ah 151x65x94mm Faston 4,8mm

No longer available

Get Quote
LIR18650 EEMB
EEMB

Ord.number: 157582

in stock 394 pcs

LIR18650

Rechargeable Batteries

Rech. battery Li-Ion 3,7V 2600mAh D18,7x65,5mm

1 pcs+ 6,12 €

2 pcs+ 5,68 €

20 pcs+ 4,98 €

60 pcs+ 4,80 €

  • ADD TO CART
  • Get Quote
  • Add to favorites
  • Add to watchdog
  • Add item to compare
Do you agree with cookies being stored?
Welcome to the SOS electronic website. Before you enter our online world, we would like to ask you to allow us to store cookies on your browser. Your consent will help us view the site without error, measure its performance, and track additional statistics. Apart from that, we can bring you an offer of our products and services, literally tailor-made. We also provide cookies to third parties. However, you are definitely safe with us.
The proper operation of the website
More stable technical control
Better marketing offer
Necessary Only selected Accept all cookies
Change the settings
Country
Select the country you are located in to receive relevant information and services tailored to your region.
Choose a language
Select your preferred language for displaying website content and communicating with our support.
Currency
Select the currency in which you want to see product prices. This way, we ensure you see current prices tailored to your needs.
Show prices with VAT
Select whether you want to display prices with or without VAT to have a better overview of costs.
Prices without VAT Prices incl. VAT